Fill Valve

Fill Valve

diy c02 injection. I found the perfect link for what I need I thought it was Plantgeek.net?

This will be my first go c02 injection. I am very excited about it, I searched around, but he thought any specific information that sounded as if they knew what they were talking. So here I am! How much of each do I need to make my boot? I'm assuming I'm going to use silicone on both sides of a bottle cap of 2 liters to fill the hole with a tube through it, air stone placed inside the aquarium, along with other end of the pipe and check valve in place to keep the gas going in the direction correct. My tank is 29 gal just need a 2 bottle of one liter .. filled?? Any experienced professionals out there?

I would use 2x 2 bottles L for good measure … The whole idea of DIY CO2 reactor is not as big … you have no control over time, pressure, quantity, or anything else really and after about a week, you'll see the amount of CO2 drop drastically. If you use two bottles, you can replace a week, giving a fairly constant flow CO2 (and much less effective than other, more expensive methods). When I DIY reactors, I used the recipe found here: http://www.fishlesscycling.com/articles/co2_discussion.html "Take a 2L Coke bottle rinsing, filling two thirds of the way with warm water and add two cups of sugar. Stir until the sugar dissolves. Add 1 teaspoon baker's or brewer's yeast. Remove the lid, and drill a hole in it that is slightly smaller than the width of some airline tubing. Airlines Cutting at an angle to create a point and pull the tip through the hole in the lid with pliers. And viola, there is no need to seal the hole with silicone! Put the lid on bottle, and you have a CO2 reactor. "This worked so well as you can expect something made from a soda bottle for the job, and a replacement for the week, made a noticeable difference.

20 lb. Aluminum Co2 Tank Compressed Gas Air Cylinder for Keg Beer $107.95 The Co2 cylinder is produced from high strength aluminum alloy 6061-T6. These tanks are popular because they are not as heavy as steel tanks and do not rust. Easy carry handle, 8″ diameter, 27.5″ height, 1800 psi, CGA-320 valve. Good for 20-25 kegs….

5 lb Aluminum CO2 Air Tank $59.55 This CO2 cylinder is produced from high strength aluminum alloy. Enjoy the benefits of aluminum tanks – they are lighter than steel tanks and do not rust! Remember, the tank must be used in a fully upright position, so do not tilt it or lay it on its side. Easy to fill; simply check out your local listings under “Gas,” or try local fire extinguisher supply or welding supply companies. In stock and…

Camco 40003 RV Water Tank Filler with Shutoff Valve $3.11 Water Tank Filler With Shut Off Valve, Large 5/8″ Fill Tube Minimize Line Backflow….

Empire 20oz CO2 Tank $14.99 Description 20 Ounce Complete Aluminum CO2 Tank with pin valve. Brand Name is PMI….

AQUATEK CO2 Paintball Tank CGA 320 Adapter $16.99 With this adapter, you can attach a CO2 regulator with CGA 320 thread to a paintball CO2 pin valve cylinder. Enhanced safety feature: pressure relief hole relieves overpressure when dettaching the adapter from CO2 cylinder (CO2 solenoid regulator and CO2 tank are not included; for demonstration purposes only)…